Performance; Names Of Each Parts - Hitachi UST-9135P Instruction Manual

MN1-5315 Rev. 14

2-3. Performance

For measurement tolerances, operating tolerances and other data, refer to the instruction manual for the
ultrasound diagnostic instrument.
2-4. Name of each parts
Probe tip
This area is held during operation.
Ultrasonic irradiation area
This incorporates an electronic
convex transducer.
Caution
Do not pull, bend, twist, or apply excessive force to the cable.
The conductors may break and the cable may become unusable.
Do not subject the ultrasonic radiation part to hard impact.
The impact may cause damage to the transducer, and that results in noise or no echo in the image.
In most cases, the ultrasonic radiation part itself is not damaged because the part is made of elastic
material.
V-groove
The needle guide is inserted to
this groove.
Follow the directions specified in
section 4-2.
Front mark
The front direction on the display.
Needle guide
Follow the directions specified in
section 4-2.
(Use one that fits adapted needle size.)
Connector
This is the part that connects the ultrasound
diagnostic instrument and probe. Follow the
instructions in section 4-5.
Lock Plate
This is used to hold the needle guide.
Follow the directions specified in section 4-2.
-16-
Cable
This cable propagates the ultrasonic
signals that are sent and received.
Guard plate
It guards the probe from needle.
Follow the directions specified in
section 4-2.