Table of Contents
Advertisement
4-3. Leaving the needle
The probe and the neede guide can be removed from the puncture needle during puncturing.
(1) Slide the lock plate to the opposite side of the front mark.
Slide the lock plate to opposite
side of the front
(2) Lift up and remove the needle guide.
(3) Take the probe off the needle.
4-4. Removal of the needle guide, the guard plate and the lock plate
Remove the needle guide, the guard plate and the lock plate using the reverse procedure to that described in
section 4-2. "Attaching of the needle guide, the guard plate and the lock plate".
(1) Slide the lock plate to opposite side of the front mark and remove the needle guide and guard plate.
(2) Slide the lock plate to the front mark side fully, then remove it.
(3) Immediately clean, disinfect and sterilize the needle guide, the guard plate and the lock plate after they
are removed from the probe.
-25-
MN1-5315 Rev. 14
Advertisement
Table of Contents
