IBM X3630 M4 Manual page 4

13. Connect the LED signal, SATA signal and power cables to the hot-swap backplane used for the rear
hard disk drive cage. They can all be found from the option package.
SATA 1 connector
14. Align the backplane with the slot on the optional rear hard disk drive cage.
15. Lower the backplane into the optional rear hard disk drive cage. Make sure the three alignment pins
securely engages the three holes on the hard disk drive cage.
SAS/SATA
backplane
16. Connect the other end of the LED signal cable to the hot-swap hard disk drive backplane in the
server.
17. Find the rear hard disk drive detect pin of the hot-swap backplane signal (I
system fan cage; then, connect with the rear hard disk drive detect pin of the LED signal cable from
the option package.
4
LED signal
SATA 0 connector
connector
Power connector
Alignment pins
Hard disk
drive cage
2
C) cable located near the