Lenovo ThinkSystem ST250 V2 Setup Manual page 88

• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines for "Handling static-sensitive devices" on page
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they do not touch each other. Do not stack
memory modules directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
– Handle memory modules with care: never bend, twist, or drop a memory module.
– Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid
metals may damage the memory modules.
– Do not insert memory modules while holding packages or passive components, which can cause
package cracks or detachment of passive components by the high insertion force.
Watch the procedure
A video of this procedure is available at YouTube:
DoEcxrm2zKNpaKOdZ3f8Qc
Procedure
Step 1. Locate the memory module slot on the system board.
The following illustration shows the location of memory module slots on the system board.
Figure 35. Memory module slots on the system board
Step 2. Open the retaining clips on each end of memory module slot.
a. Place the tip of the tool in the recess on the top of the retaining clip.
b. Carefully rotate the retaining clip away from the memory module slot.
ThinkSystem ST250 V2 Setup Guide
80
https://youtube.com/playlist?list=PLYV5R7hVcs-
.
64.