Lenovo ThinkSystem ST250 V2 Setup Manual page 70

Attention: Prevent exposure to static electricity, which might lead to system halt and loss of data, by
keeping static-sensitive components in their static-protective packages until installation, and handling these
devices with an electrostatic-discharge wrist strap or other grounding system.
• Read the safety information and guidelines to ensure your safety at work:
– A complete list of safety information for all products is available at:
help/topic/safety_documentation/pdf_files.html
– The following guidelines are available as well:
• Make sure the components you are installing are supported by the server. For a list of supported optional
components for the server, see
• When you install a new server, download and apply the latest firmware. This will help ensure that any
known issues are addressed, and that your server is ready to work with optimal performance. Go to
ThinkSystem ST250 V2 Drivers and Software
Important: Some cluster solutions require specific code levels or coordinated code updates. If the
component is part of a cluster solution, verify the latest Best Recipe code level menu for cluster supported
firmware and driver before you update the code.
• It is good practice to make sure that the server is working correctly before you install an optional
component.
• Keep the working area clean, and place removed components on a flat and smooth surface that does not
shake or tilt.
• Do not attempt to lift an object that might be too heavy for you. If you have to lift a heavy object, read the
following precautions carefully:
– Make sure that you can stand steadily without slipping.
– Distribute the weight of the object equally between your feet.
– Use a slow lifting force. Never move suddenly or twist when you lift a heavy object.
– To avoid straining the muscles in your back, lift by standing or by pushing up with your leg muscles.
• Make sure that you have an adequate number of properly grounded electrical outlets for the server,
monitor, and other devices.
• Back up all important data before you make changes related to the disk drives.
• Have a small flat-blade screwdriver and a small Phillips screwdriver available.
• You do not have to turn off the server to remove or install hot-swap power supplies or hot-plug USB
devices. However, you must turn off the server before you perform any steps that involve removing or
installing adapter cables, and you must disconnect the power source from the server before you perform
any steps that involve removing or installing a DIMM.
• Blue on a component indicates touch points, where you can grip to remove a component from or install it
in the server, open or close a latch, and so on.
• Terra-cotta on a component or a terra-cotta label on or near a component indicates that the component
can be hot-swapped if the server and operating system support hot-swap capability, which means that
you can remove or install the component while the server is still running. (Terra-cotta can also indicate
touch points on hot-swap components.) See the instructions for removing or installing a specific hot-swap
component for any additional procedures that you might have to perform before you remove or install the
component.
• The Red strip on the drives, adjacent to the release latch, indicates that the drive can be hot-swapped if
the server and operating system support hot-swap capability. This means that you can remove or install
the drive while the server is still running.
Note: See the system specific instructions for removing or installing a hot-swap drive for any additional
procedures that you might need to perform before you remove or install the drive.
ThinkSystem ST250 V2 Setup Guide
62
"Handling static-sensitive devices" on page
https://static.lenovo.com/us/en/serverproven/index.shtml
to download firmware updates for your server.
http://thinksystem.lenovofiles.com/
64.
.