Maserati GRANCABRIO Owner's Manual page 85

Customer Service
If you have any problems with
confi guring and programming the
HomeLink system or if you would
like to know what devices can be
connected to it, call the toll-free
number 008000 466 345 65 or visit the
Web site: www.eurohomelink.com.
Safety Precautions
For using the HomeLink feature,
follow the instructions and safety
indications given in the User Manual
that the manufacturer must provide
together with the device to be
controlled. If you do not have this
manual, request it from the supplier.
Before opening or closing a gate or
door make sure that the procedure
can be performed in thorough safety,
i.e. make sure that you can see the
whole range of action of the gate or
door and also check that there are
no persons, animals or other objects
within this range.
General information
While programming HomeLink, it
is advisable to disconnect the drive
motor of the gate/door to be remote-
controlled, since the numerous driving
pulses launched for this operation
might damage it.
If the battery fails or is disconnected,
the stored settings are not deleted.
If the gate/door was manufactured
prior to 1982 (not equipped with
safety systems or automatic stop in
the event of an obstacle in the range
of action), the gate/door cannot be
controlled by HomeLink.
For more information in this regard,
please contact the Customer Service.
Confi guration according to the
country of use
The system is normally set to the
operating mode for the country
where the vehicle is sold.
Procedure for selecting the country of
operation:
1. press and hold buttons O and Q;
2. after approx. 20 seconds the
LED R starts fl ashing, indicating
that all the three programmable
channels have been reset;
3. hold down buttons O and Q
until the LED goes off (about 10
seconds) then release the buttons;
4. again press buttons O and Q;
5. after one second, press button
P; when it is released, the LED
R starts fl ashing; the number of
fl ashes shows the operating mode
for the country (see the table
"Countries of Operation");
6. press button P when reaching the
number of fl ashes corresponding
to the relative country.
At the end of the fl ashing cycle (4
fl ashes), the fl ashing sequence restarts
from scratch.
3
83