Maserati GRANCABRIO Owner's Manual page 54

The distance from the obstacles can
also be graphically shown on the
instrument panel display by means
of an image that shows the vehicle
surrounded by explanatory symbols
of the distance (maximum/average/
minimum) and the position (front/
rear/central/side) of the obstacle
2
detected.
The colour represents the distance,
while the fi eld represents the
position. The green colour represents
the maximum distance detected, the
yellow colour the medium distance
and the red colour the minimum one.
If the vehicle is equipped only with
rear sensors, the front sensors are not
shown in the image.
If the vehicle is equipped with front
and rear sensors, the rear sensors are
not shown in the image if only the
front sensors are active.
52
Stop & Go function
The vehicle is equipped with a Stop
& Go function that can be activated
through the Multi Media System.
The Stop & Go function can be
enabled/disabled by accessing the
"Confi guration" menu, selecting the
"Defi ne vehicle parameters" option,
then the Stop & Go parking option
and setting it to "Activation". With
the Stop & Go function active, the
front sensors will automatically be
activated in all conditions where the
vehicle speed drops below 8 km/h
(5 mph).
WARNING: The Stop & Go function
is only available if the vehicle is
equipped with front parking sensors.
For the system to operate
correctly, the sensors
positioned on the bumper
must be kept clean (remove any mud,
dirt, snow or ice).
Cleaning the sensors
When cleaning the sensors, take
special care not to scratch or damage
them; therefore, do not use dry,
rough or hard cloths.
The sensors must be washed with
clean water, possibly with car
shampoo added.
Should you need to repaint the
bumper or in case of paint touch-ups
in the sensors area, please contact
exclusively the Maserati Service
Network. Incorrect paint application
could affect the parking sensor
operation.