Maserati GRANCABRIO Owner's Manual page 107

The storage procedure is only possible
with the ignition key in position
MAR. Adjust the position of the seat,
the external rear-view mirrors and
the steering wheel, then engage
reverse gear and position the external
passenger's mirror again to ensure the
best possible visibility for reversing,
then disengage reverse gear. Next
press one of the three buttons "1",
"2" or "3", each corresponding to
a memorisable position, for more
than 3 seconds until you hear a
confi rmation tone.
Lumbar support adjustment is not
included in the seat position storage
procedure.
The memorisation of a new seat
position cancels the one previously
stored with that particular button.
To recall one of the stored positions
with the door open, press the relative
button "1", "2" or "3" briefl y.
To recall the a stored position
with the door closed, press the
corresponding button until hearing
a tone that confi rms the seat has
stopped.
WARNING: To stop the seat, press one
of the buttons - "1", "2" or "3" -, or
one of the adjustment controls.
WARNING: Malfunctioning of the seat
control unit is indicated by a sequence
of 5 tones emitted when the ignition
key is turned to STOP: contact the
Maserati Service Network to have the
malfunction corrected.
Each system is independent of the
others and can be operated separately
using specifi c buttons for each seat.
System initialisation
Following any power cut-out (e.g.
after using the battery master switch
or dead battery), check the seats
to ensure that they are operating
properly when the power supply
is available: perform the following
procedures on both seats in the event
of a malfunction.
With the ignition key in position
STOPand the door on the side of the
seat concerned closed, open the door
and begin the following procedure
within 5 seconds, then complete it
within 10 seconds:
1) forward - STOP;
2) backward - STOP;
3) forward - STOP;
4) backward - STOP;
5) tilt the seatback fully forward and
wait until the seat performs two
complete travels (forward and
backward);
6) move the seatback to its normal
upright position.
WARNING: If you need to disconnect
the battery, wait at least 30 seconds
from the last seat movement.
If you disconnect the battery before,
you will have to run the initialisation
procedure.
4
105