Charge Status; Charging - Bosch IR LD 1.0 Operator's Manual

7.3.2

Charge status

Available battery power is shown
in the upper right corner of the
display as both a battery icon and
a percentage (see Fig. 18).
i
When charge is depleted to or
below 15%: the inner segments
of the battery icon will turn red
(see Fig. 18) to indicate that
the battery requires charging
(Refer to Section: 7.3.3).
A
CO₂
Fig. 18: Low Battery status (top right)
7.3.3

Charging

1. Connect the micro-USB con-
nector cable to the charging
port located at the base of the
IR LD 1.0 (see Fig. 19).
2. Connect the other end of the
micro-USB cable to the provid-
ed 5V DC 1.0A wall charger.
3. Connect wall charger to main
power supply.
Bosch Automotive Service Solutions GmbH
Maintenance | IR LD 1.0 | 33 | en
 With power OFF and charger
4. Allow the IR LD 1.0 to charge
until the display shows 100%.
i
The battery takes approximately
3 hours to charge completely.
15%
Fig. 19:
1. Charging port
i
It is possible to use a 12V
DC power source, if the USB
adapter outputs a minimum
1.0A.
i
Avoid completely depleting
the battery. Recharging a
partially depleted battery more
frequently is better for the life
of a lithium-ion battery.
connected, the charging sta-
tus screen is displayed (see Fig.
20).
Charging Leak detector
SP01502142 | 14.03.2022