KBL P9 Operating Manual

Service information
Topic: Retrofit filter capacitors in the canopy
Subject: P9/P9S (5018) devices
This operating manual is intended for use by
• qualified, trained and authorized service technician.
• qualified electrician.
SAFETY ADVICE
Before carrying out any maintenance work, the tanning device must be disconnected from
the mains voltage and secured against being switched on again.
DANGER
Live parts
Risk of death or fatal injury due to electric
shock when touching live parts.
• Switch neutral
• Secure against reconnection
• Check for neutrality
• Ground and short-circuit
• Cover or shield any adjacent live parts or
components
Service information: SI00094 The rights to technical and design alterations are reserved. KBL GmbH · Ringstraße 24-26 · 56307 Dernbach · Germany
fon +49 (0) 26 89.94 26-0 · fax 94 26-66 · eMail info@kbl.de · www.kbl.de
❶
Remove the old filter capacitor.
• Disconnect the old capacitor at the plug
connector (as shown in the image).
• Loosen the cable ties.
• Disconnect ground connection.
Depending on the delivery status, one or
two capacitors are installed.
• Only remove the capacitor at the lower
LED panel.
01/2022
1/3