Using Dante Controller; Dante Controller Overview; Audio Routing Settings; Changing Sampling Frequencies And Bit Depths With Dante Controller - Tascam SB-16D Owner's Manual

Using Dante Controller

Dante Controller overview

This unit uses the Dante Controller application, which is
available at the Audinate website, to connect with other devices
that support Dante.
Download the latest version of the Dante Controller application
and an operation manual from the Audinate website.
Audinate download page
https://www.audinate.com/products/software/dante-
controller
Make at least the following settings using a computer that has
Dante Controller installed.
o Set the audio routing.
o Adjust the sampling frequency and bit depth of each Dante
device.
NOTE
Settings made using Dante Controller are stored in the built-
in memory of each Dante device.
Unless settings are modified, connections will not
change even if Dante Controller is quit or the computer is
disconnected from the Dante network.

Audio routing settings

When Dante Controller is launched, the Network View screen
shown below will open.
On this screen, you can set and monitor conditions related to
the Dante network.
1Receiving device name
This is the name of a receiving device on the Dante network.
2Receiving device channels
These are the names of the channels of the receiving device
on the Dante network.
3Transmitting device name
This is the name of a transmitting device on the Dante
network.
4Transmitting device channels
These are the names of the channels of the transmitting
device on the Dante network.
14
TASCAM SB-16D
5Audio routing
Route the audio channels of the transmitting and receiving
devices that you want to connect here.
Click the intersection of the channels you want to connect
on the matrix to connect them.
NOTE
While pressing the computer keyboard Ctrl key, click the "-" at
the intersection of device names to connect all connectable
channels at once.
Changing sampling frequencies and bit
depths with Dante Controller
Double-click a device name on the Network View screen to open
the Device View screen.
On this screen, you can set and monitor conditions related to
devices on the Dante network.
Click the Device Config tab to open the page where you can
change the sampling frequency, bit rate and other settings of
the device selected in 1 shown in the illustration below.
1Device name
This is the name of the device that can have its settings
changed in the current Device View.
2Change device name
Edit the device name.
3Sampling frequency
Set the sampling frequency.
4Bit depth
Set the bit depth.
5Latency setting
Set the latency.
ATTENTION
Changing the name of a device will clear audio routing
settings. For this reason, we recommend changing device
names to names that are easy to identify before setting audio
routings.