Table of Contents
Advertisement
Application overview
Using the TASCAM IO CONTROL application, the unit can be operated and its functions can be set remotely.
For details about the application, please see its Owner's Manual.
The TASCAM IO CONTROL application and its operation manual can be downloaded from the TEAC Global Site (https://teac-global.com/).
For details about function that can be set, see "Parameter list" on page 15.
Overview of settings
Make various settings as necessary according to the connected equipment.
The following settings can all be made using the TASCAM IO CONTROL application. In addition, when used together with a Sonicview,
various settings can be made from the Sonicview. See "Using as a Sonicview extension" on page 12 for details.
Setting mic/line inputs
Mic and line input settings can be made.
Gain, pad and trim settings can also be made in these input settings.
Setting phantom power
Phantom power can be turned on when an external mic that requires it is connected to the unit.
This can be turned on/off independently for each channel.
ATTENTION
i Before connecting condenser mics, turn this unit and all equipment to be connected off (standby).
i Do not connect or disconnect mics while phantom power is on. Doing so could cause a loud noise and might damage this unit and
connected equipment.
i Turn phantom power ON only when using a condenser microphone that requires phantom power. Turning phantom power on when
a dynamic mic or other mic that does not require it is connected could damage this unit and connected equipment.
i Supplying phantom power to some ribbon mics could break them. If unsure about a ribbon mic, confirm with the mic manufacturer
or do not supply phantom power to it.
Setting the reference level
You can set the analog input and output headroom (difference between the maximum and reference levels).
Device ID settings
When using an SB-16D with a Sonicview 16/24, the device ID must be set to enable identification of the unit.
Follow the procedures below to check or change the device ID.
Checking the device ID
Press the ID (5) button.
The unit will enter device ID checking mode, and the STATUS and SAMPLE RATE indicators will blink.
INPUT SIG indicators and OUTPUT SIG indicators will light at the same time according to the device ID number.
The device ID is assigned by pairing the numbers of the input and output channel indicators.
For example, indicators will light for the following ID numbers as shown in the tables.
Device ID: #3-4
Channel number
INPUT SIG indicators
OUTPUT SIG indicators
Device ID: #15-8
Channel number
INPUT SIG indicators
OUTPUT SIG indicators
i Indicators that light when in device ID confirmation mode
1
2
3
4
5
0
0
1
2
3
4
5
6
7
8
9
10
11
6
7
8
9
10
11
0
12
13
14
15
16
12
13
14
15
16
0
11
TASCAM SB-16D
Advertisement
Chapters
Table of Contents
