Ford Fiesta 2010 Owner's Manual page 126

CAUTIONS
Wheel nuts of alloy wheels and
spoked steel wheels can only be
used for the steel spare wheel for a
maximum of two weeks.
Note: The spare wheel is located under
the floor cover in the luggage
compartment.
1. Insert the flat end of the wheel brace
between the rim and the hub cover
and carefully remove the hub cap or
cover.
E90922
2. Install the locking wheel nut key.
3. Slacken the wheel nuts.
E113399
4. Install the jack to the flange.
Wheels and tyres
5. Extend the jack until the base of the
E113400
6. Jack up the vehicle until the tyre is
7. Remove the wheel nuts and the
Installing a road wheel
the National Type Approval invalid. See
Technical specifications (page 129).
for more details regarding compatibility.
Note: Make sure the wheel and hub
contact surfaces are free from foreign
matter.
Note: Make sure that the cones on the
wheel nuts are against the wheel.
1. Install the wheel.
124
(G1085119)
jack is flat on the ground, vertically
below the jacking point.
clear of the ground.
wheel.
WARNINGS
Use only approved wheel and tyre
sizes. Using other sizes could
damage the vehicle and will make
Do not fit run flat tyres on vehicles
that were not originally fitted with
them. Please contact your dealer
CAUTION
Do not install alloy wheels using
wheel nuts designed for use with
steel wheels.