Table of Contents
Advertisement
20 Pulse Mode
The pulsed mode creates a series of short bursts of defined duration and repetition rate (period). The
number of applied pulses and amplitude rate-of-chage (ramp rate) can also be chosen. Phase tracking
can be used in pulsed-mode; however, it will converge slowly due to the low duty cycle.
Pulse Length - Pulse length in milliseconds, the minimum is 0.1
Pulse Period - Pulse period in milliseconds, the minimum is 0.2
Number of Pulses - Number of pulses before the output is disabled. Continuous output if set to zero.
Ramp Rate - Sets the rate of change in amplitude, in Volts per millisecond.
Off Voltage - Output voltage when the pulse is off.
Start Button – Start and stop pulse output.
PDUS210 V5 Manual
27
Modified 17/12/2022
Advertisement
Table of Contents
