SOMFY Wirefree TL25 Quick Programming Manual

TL25 Wirefree™ RTS External Battery
Quick Programming Guide
IMPORTANT:
Upper and lower limits are set at the factory. In the event limit
setting is required, follow steps to RESET MOTOR TO FACTORY MODE and proceed
with INITIAL PROGRAMMING AND LIMIT SETTING.
1) Supply power to the motor. The shade will jog 3 times.
2) PRESS & HOLD the PROGRAMMING BUTTON on the motor until the shade jogs once.
3) Choose the transmitter you wish to control the shade and choose the appropriate channel for control.
4) BRIEFLY PRESS the PROGRAMMING BUTTON on the transmitter. The shade will jog once.
The transmitter is now paired. You can now install the shade.
ADJUSTING THE LIMITS IN USER MODE
Step 1:
Move the shade to the
current limit position you wish
to adjust and let it stop.
Adjusting the
Upper Limit
Adjusting the
Lower Limit
INITIAL PROGRAMMING AND LIMIT SETTING
NOTE: Motor will exit programming mode after 2 minutes of inactivity. While in programming mode, the shade only operates when UP or DOWN buttons
are continuously pressed.
Step 1:
To initiate programming
PRESS & HOLD the UP and DOWN
buttons at the same time until the
shade jogs.
Step 3:
Bring the shade to your desired upper
limit. Make sure it is not too compressed.
PRESS & HOLD both the MY/STOP &
DOWN buttons until the shade begins to
move down, then release. Stop the shade at
the desired lower limit, adjust if needed.
In user mode a brief press of the UP or DOWN button will send the shade to the respective limit.
Copyright © Somfy SAS 8/2022
Step 2:
PRESS & HOLD both UP
and DOWN buttons simultaneously
until the shade jogs, then release.
Step 2:
Check the direction of
operation. Press the DOWN button
and confirm the shade lowers.

Step 4:
PRESS & HOLD the UP
and MY/STOP buttons until the
shade begins to move up.
The shade will stop at the original
upper limit.
P-0057CBG www.somfysystems.com
Step 3:
Adjust to a new
limit position using the UP
or DOWN buttons.
If the shade raises instead of lowering, change the direction - PRESS &
HOLD the MY/STOP button until the shade jogs. Confirm correct direction
of operation before proceeding.
Step 5:
PRESS & HOLD
the MY/STOP button
until the shade jogs to
confirm both limit
settings.
Programming
Button
Step 4:
PRESS & HOLD
the MY/STOP button until
the shade jogs, then release.
Check the new limit.

Step 6:
To finalize BRIEFLY
PRESS the PROGRAMMING
BUTTON on the back of the
control. The shade will jog and
will now operate in user mode.