Table of Contents
Advertisement
ELECTRICAL CONNECTION
1
2
3
Unscrew and remove the junction box
cover to access the terminal block.
Do not remove the screw holding the
junction box bracket in place.
Install the strain relief into the junction
box bracket and secure the house
wiring or the power cord and tighten.
Thread the wires through the hole in
the junction box bracket and connect
the incoming ground to green, white to
white and black to black.
Refit the junction box cover ensuring
no wires are pinched beneath the cover.
Ensure the power cord is routed under
the appliance.
Ensure product does not have live
power until this installation is complete.
INSTALL HARD PLUMBING
1
2
3
Fitting copper pipe:
Slide the compression nut and ferrule
towards the end of the pipe. Insert the
end of the pipe into the elbow and
screw the compression nut to the thread
of the elbow.
Braided hose installations:
Screw the nut of the hose to the thread
of the elbow. Hand-tighten then using
a spanner or pliers, turn a further 180°
to secure.
Connecting elbow to inlet valve:
Connect a 90° elbow to the water inlet
valve. Ensure a rubber gasket is placed
between the threads of the elbow and
water supply valve. The end of the elbow
must point to the rear of the dishwasher.
Do not over tighten the elbow.
Briefly turn on the water supply and
check for leaks, once you are satisfied
the connections will not leak turn off the
water supply.
13
Advertisement
Table of Contents
