Intended Use; Operating Instructions; Maintenance; Environmental Protection - Worx WX463 Instructions Manual

drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions. .
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.

4. INTENDED USE

The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly
on the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw blade
recommendations are to be observed.

5. OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY AND OPERATION
Action
Blade Installation
Blade Removing
Variable Speed Control
Pendulum Function
ON/OFF Switch
Lock-On Button
Straight Cut and Curve Cut
Jigsaw
Bevel Cut
Plunge Cut
Vacuum Adaptor

6. MAINTENANCE

Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
7. ENVIRONMENTAL
PROTECTION
local authorities or retailer for recycling advice.
Figure
See Fig. A1
See Fig. A2
See Fig. B
See Fig. C
See Fig. D
See Fig. D
See Fig. E1, E2
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
See Fig. F, G
See Fig. H
See Fig. I
9
EN