GE SR345 Instruction Manual page 48

SOFTWARE SETUP
3–12
Courtesy of NationalSwitchgear.com
If you are going to communicate from your computer to the 345 Relay using the USB
port:
10. Plug the USB cable into the USB port on the 345 Relay then into the USB port on your
computer.
11. Launch EnerVista SR3 Setup from LaunchPad.
12. In EnerVista > Device Setup:
13. Select USB as the Interface type.
14. Select 345 Relay as the USB device.
345 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INTERFACES