Husqvarna R 418TsX AWD Operator's Manual page 124

Problem
The engine does not start when
the starter motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
The transmission does not have
sufficient power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry
124
Cause
There is no fuel in the fuel tank. Refer to
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburetor or fuel line.
The spark plug is defective.
The carburetor is incorrectly set.
The air filter is clogged. Refer to
There is dirt in the carburetor or fuel line.
The air filter is clogged. Refer to
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The cold air intake of the transmission or the cooling fins are blocked.
The fan on the transmission is damaged.
There is no oil in the transmission or the oil level is too low. Refer to
check of the transmission oil level on page 121 .
The battery is defective. Refer to
The connection at the cable connectors on the battery terminals is bad. Refer to
To charge the battery on page 115 .
The blades, the pulley or other rotating parts are loose. Refer to
page 109 .
One or more of the blades are not balanced. Refer to
page 119 .
The engine is loose.
The blades are blunt. Refer to
The grass is long or wet. Refer to
The cutting deck is damaged and not parallel to the ground.
There is grass blockage in the cutting deck. Refer to
page 111 .
The tire pressure is different on the right and left sides. Refer to
page 116 .
The product is operated at a too high ground speed. Refer to
cutting result on page 109 .
The engine speed is too low. Refer to
The drive belt loosens from the pulleys.
To fill fuel on page 106 .
To clean and change the air filter on page 114 .
To clean and change the air filter on page 114 .
To charge the battery on page 115 .
To examine the blades on
To replace the blades on page 119 .
To get a good cutting result on page 109 .
To clean the product on
To get a good cutting result on page 109 .
To do a
Maintenance on
Tire pressure on
To get a good
880 - 009 - 31.10.2022