Subscribe to Our Youtube Channel
Related Manuals for GreenWorks Pro GPW2500C
Summary of Contents for GreenWorks Pro GPW2500C
- Page 1 GPW2500C PRESSURE WASHER OPERATOR MANUAL LAVEUSE À PRESSION MANUEL DE L’UTILISATEUR LAVADORA A PRESIÓN MANUAL DEL OPERADOR PWA207 www.greenworkstools.com...
-
Page 3: Table Of Contents
English Description........4 Install the spray wand....8 Purpose............4 10 Install the high pressure Overview............ 4 hose..........8 General power tool safety 11 Operation........8 warnings........4 11.1 Connect the water supply to the General power tool safety warnings... 4 machine............8 Electrical safety warnings......4 11.2 Use the spray gun........ -
Page 4: Description
English DESCRIPTION The term “power tool” in the warnings refers to your mains-operated (corded) power tool. PURPOSE GENERAL POWER TOOL SAFETY The machine is used to used to clean vehicles, boats, WARNINGS buildings, porches, decks, patios, and driveways. • The machine is not intended for use by persons For residential use and professional use, and for (including children) with reduced physical, sensory operation at temperature above 32°F (0°C). -
Page 5: Pressure Washer Safety Warnings
English SERVICING OF A DOUBLE from heat and sharp edges. Always disconnect the extension cord from the receptacle before INSULATED APPLIANCE disconnecting the product from the extension cord. • Within a double insulated product, two systems of • Do not use the appliance if a supply cord or insulation are provided instead of grounding. -
Page 6: Proposition 65
English PROPOSITION 65 Symbol Explanation Failure to use in dry conditions WARNING and to observe safe practices can This product contains a chemical known to the result in electric shock. state of California to cause cancer, birth defects Fuel and its vapors are explosive or other reproductive harm. -
Page 7: Unpack The Machine
English INSTALL THE UPPER PANEL on direct current (DC). A considerable voltage drop will cause a loss of power and the motor will be overheated. 3.1.1 PREPARE A DRIP LOOP Recommend the use of a drip loop as below so the water can not run along the power cord even possibly reach the electrical outlet and plug. -
Page 8: Install The Power Cord Storage Arms
English INSTALL THE POWER CORD 1. Push the end of the spray wand (4) into the trigger handle (1) and rotate clockwise to secure. STORAGE ARMS 2. Pull on the spray wand (4) to be certain it is properly secured. WARNING Make sure that the connection has no leakage. -
Page 9: Use The Spray Gun
English • Release the spray gun trigger (21) to stop water flow WARNING through the spray tip. Always observe all the local regulations when you 11.2.1 UNLOCK THE SPRAY GUN TRIGGER connect the garden hose to the water supply. Direct connection through a receiver tank or backflow •... -
Page 10: Add Detergent
English 11.4 ADD DETERGENT SPRAY TIP APPLICATION Green - Narrow fan tip (25° ) • The green pressure washer tip provides high versatility with its 25 degree angle tip. Referred to as the washing tip, because it provides adequate pressure to re- move dirt from surfaces, but is de- signed to not damage many sur- faces. -
Page 11: Start The Machine
English 11.5 START THE MACHINE will reset automatically once the pump relives the excess heat. MAINTENANCE WARNING Before maintenance, make sure that you • Stop the machine. • Wait until all the moving parts stop. • Disconnect the plug from the power source. WARNING Do not use strong solvents or detergents on the plastic CAUTION... -
Page 12: Adding Lubricating Oil
English 12.1.2 CLEAN THE SPRAY TIP 1. Use a straight paper clip or cleaning tool (20) to clean the spray tip. 2. Flush and clean the unwanted materials out of the spray tip (18) with the garden hose (17). 3. Install the clean spray tip (18) back into the spray wand (4). -
Page 13: Troubleshooting
English • Replace the damaged parts. PROBLEM POSSIBLE SOLUTION • Tighten the bolts. CAUSE • If needed, call the customer service phone The water supply Open water sup- number (enter number here) for servicing is not sufficient. ply fully. Check instructions. -
Page 14: Technical Data
English PROBLEM POSSIBLE SOLUTION Weight 58.74 lbs. (26.7 kg) CAUSE Double-insulated con- The motor buz- The supply volt- Make sure that struction. zes, but the ma- age is low. only the pres- chine does not sure washer is start. running on the LIMITED WARRANTY circuit. -
Page 15: Exploded View
English P.O. Box 1238 P.O. Box 93095, Newmarket, Ontario Mooresville, NC 28115 L3Y 8K3 EXPLODED VIEW ITEM NO. PART NO. DESCRIPTION C1108880-00 15°spray Tip C1102282-00 25°spray Tip C1102283-00 40°spray Tip 31202994 Turbo Nozzle 311051398 Soap Tip C4100577-00 Spray Gun Holder C3200440-00 Upper Handle C3200441-00... - Page 16 English C1105738-00 Wheel Assembly C3203688-00 Lower Handle C4102801-00 Lower Housing C1108166-00 Motor Assembly C4102800-00 Upper Housing C6200015-00 Power Switch C1104424-00 PCB Board C1101554-00 Spray Wand C1104426-00 Spray Gun C1108834-00 High Pressure Hose 312232582 Adaptor C3300335-00 Water Pipe Connector C1108257-00 Quick Connector C3204574-00 Quick Connector C1108362-00...
Need help?
Do you have a question about the GPW2500C and is the answer not in the manual?
Questions and answers
Is there a valve that turns the soap/detergent on and off?
No, the GreenWorks GPW2500C does not have a valve to turn the soap or detergent on and off. Soap or detergent is applied only when the black 75-degree nozzle is installed, which operates under low pressure and high volume.
This answer is automatically generated
Dimensions of the box for 2500 PSI electric power washer