Contact Inputs Events Setting; General Settings - SECURECOM SC-GSM M2 Installation Manual

6.3 Contact inputs events setting

The device has 2 contact inputs, with NO or NC setting. For alarm notifications, the contacts must be
connected to the DC - negative supply voltage. Sensitivity means that the event (short circuit or
interruption) that triggers the alarm must persist for at least the time set there. In case of a contact
event, the alarm device shall notify the selected telephone numbers by means of an alarm call
and/or SMS message. The SMS message can be specified individually.

6.4 General settings

In this window you can change the parameters related to the operation of the communicator.
SIM PIN:
the PIN code of the inserted SIM card must be entered if PIN code request is set
Ringing time:
ringing time of the called phones in seconds (for limiting voicemail)
Call time:
the siren time on the called telephone in seconds
Alarm time:
event notification expiry time in seconds
SMS limit:
daily limit for sending SMS
Call limit:
daily limit for alarm calls
Operation mode:
mode selector for the desired use (as mentioned above)
Test SMS period:
frequency of periodic test report that the unit works properly
Test SMS text:
message of periodic test report that the unit works properly
SC-GSM M2
manual v2.0
8 EN