Midea GAIA Series User Manual page 88

5. APP DECLARATION
Hereby, we declare that this Smart kit is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU. A copy of the full DoC is attached.
(European Union products only)
CAUTIONS:
WIFI module models: US-SK105,EU-SK105:
FCC ID: 2ADQOMDNA21
IC: 12575A-MDNA21
This device complies with Part 15 of the FCC Rules and it contains licence-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s).
Operat ion is sub ject to the f ollow in g two con d ition s:
(1) T his d evice may not cause int erferen ce; a nd
(2) T his d evice must accep t a ny in terfe re nce , including inte rf erence tha t may ca use
und esire d op erat ion of the de vice .
Only operate the device in accordance with the instructions supplied. Changes or
modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with FCC
radiation exposure limits set forth for an uncontrolled environment. In order to avoid
the possibility of exceeding the FCC radio frequency exposure limits, human proximity to
the antenna shall not be less than 20cm (8 inches) during normal operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
--Consult the dealer or an experienced radio/TV technician for help.
 
Page 17