Table of Contents
Advertisement
GLASS REPLACEMENT
1.
Remove door from stove and lay
on a padded flat surface.
2.
Remove glass tabs (See figure
25) and screws with a Phillips
screwdriver (turn screws counter-
clockwise).
3.
Lift glass frame pieces and glass
out of the door frame.
4.
Lay new glass with fiberglass tape
around it into the door frame, mak-
ing sure the Heat-N-Glo logo reads
correctly to the outside.
5.
Place glass frame pieces over the
fiberglass tape on the edges of the
glass. Be sure glass is centered
in the opening (i.e., same space
top and bottom, left and right
sides).
6.
Reinstall screws and glass tabs tight enough to
hold glass and frame in place. DO NOT OVER-
TIGHTEN.
7.
Check again for centering of glass in door frame,
and give all screws a final tightening.
DOOR HANDLE ASSEMBLY
NOTE: Spring handle not included in
door handle assembly. When replacing
door handle, either use old spring
handle or order new spring handle
separately (See Figure 26).
FIGURE 25
FIGURE 26
23
Advertisement
Table of Contents
