Leds; Jumpers - gefran SIEIDrive EXP-F2E Instruction Manual

+5V ������������������������ Il led è acceso quando è presente la tensione +5V fornita dal
5ENC ����������������������� Il led è acceso quando viene fornita la tensione +5V al morsetto
24ENC ���������������������� Il led è acceso quando viene fornita la tensione +15...24V al
+5VE ����������������������� Il led è acceso quando viene fornita l'alimentazione per i driver
DRV ������������������������ Il led è acceso quando viene fornita l'alimentazione per i driver
Name
S1 and S2 Setting divider for encoder repeater (see table below) OFF, OFF
S7
Settare il Jumper S7 su ON quando occorre l'allarme mancanza encoder anche per il canale
di zero (attivo solo quando viene utilizzato un encoder complementare digitale 15V/24V)
Set Jumper S7 to ON when encoder loss detection is used also for zero channel. (Alarm
active only if a digital encoder with all A, Anot, B, Bnot channels and +15V to 24V power
supply is used)
10
———— Digital Encoder Input Expansion and Encoder Repeater ————

4. Leds

Drive.
The led is lit when internal +5V power supply is available from
the Drive.
XSI.
The led is lit when +5V power supply is provided by XSI terminal.
morsetto XSI.
The led is lit when +15 to 24V power supply is provided by XSI
terminal.
TTL (+5V).
The led is lit when power supply for driver encoder repeater TTL
(+5V) is provided.
HTL (+15...24V).
The led is lit when power supply for driver encoder repeater TTL
(+15 to 24V) is provided.

5. Jumpers

Description
ON 0 Channel included in the encoder loss logic
OFF 0 Channel not included in the encoder loss logic
DIVIDER FOR ENCODER REPEATER SELECTION
Encoder divider Jumper S1
/1
/2
/4
/8
Jumper S2
OFF OFF
OFF ON
ON OFF
ON ON
Default
OFF
exp2F70
exp2F80