Subscribe to Our Youtube Channel
Related Manuals for TLV SF1
Summary of Contents for TLV SF1
- Page 1 172-65387MA-08 (SF1 Separator Filter) 1 October 2021 Separator Filter Copyright © 2021 by TLV CO., LTD. All rights reserved...
-
Page 2: Table Of Contents
The SF1 separator filter combines a high-performance filter with a cyclone separator that removes dirt, scale and condensate (entrained moisture) by means of centrifugal force and gravity. The SF1 can be used for both separator and filter applications. It is suitable for use in steam and air mains, and in applications calling for high-quality steam and air. -
Page 3: Safety Considerations
The three types of cautionary items above are very important for safety: be sure to observe all of them as they relate to installation, use, maintenance and repair. Furthermore, TLV accepts no responsibility for any accidents or damage occurring as a result of failure to observe these precautions. - Page 4 Use only under conditions in which no water hammer will occur. The impact of water hammer may damage the product, leading to fluid discharge, which may cause burns or other injury. 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021...
-
Page 5: Specifications
* Maximum allowable pressure (PMA) and maximum allowable temperature (TMA) are PRESSURE SHELL DESIGN CONDITIONS, NOT OPERATING CONDITIONS. ** Valve No. is displayed for products with options. This item is omitted from the nameplate when there are no options. 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... -
Page 6: Configuration
Configuration Part Name Body Separator Separator Body Separator Bottom Baffle Filter Filter Gasket Body Clamp Body Gasket Nameplate Clamp Bolt Spring Washer Clamp Nut 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... -
Page 7: Installation
8. The product must be installed horizontally and with no more than 10° inclination horizontally and front-to-back. Tolerance Angle for Installation: 10° The product should be installed so that the letters TLV on the body are horizontal. 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... - Page 8 Ensure the maintenance space is sufficient for maintenance (i.e. replacement of internal filter). SF1 Connection Size Min. Maintenance Space (S) (in) (in) 15, 20 (12) (14) If there is a problem, determine the cause using the Troubleshooting section of this " " manual. 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021...
-
Page 9: For Longer Filter Life
Blowdown/condensate discharge Dirt and scale blowdown * Ahead of the inlet valve for the SF1, install a valve for piping blowdown or a steam trap with sufficient discharge capacity when differential pressure is extremely low. 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... -
Page 10: To Minimize Pressure Loss Effects
In cases where more stable pressure is needed Installing a COSPECT pressure reducing valve* with an external pressure sensing line from the outlet of the SF1 will help supply stable pressure and minimize pressure drop, which gradually increases due to build-up of dirt/scale at the filter. -
Page 11: Maintenance
Inlet valve is closed Outlet valve is closed Pressure Gauge Union Steam Trap Trap inlet valve is closed Hot/cold water, steam, or air (valve open) Dirt and scale collection Blowdown valve is open 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... -
Page 12: Disassembly/Reassembly
Assemble the separator onto the body sealing surface on the separator together with the filter and body Filter Gasket 7 Remove, being careful not to Replace with a new gasket if warped or scratch the surface damaged 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... - Page 13 Body Separator Separator Body Separator Bottom (fixed to Separator Body) Baffle (not shown, fixed to Separator Bottom) Filter Filter Gasket Body Clamp Body Gasket Nameplate (not shown) Clamp Bolt Spring Washer Clamp Nut 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021...
-
Page 14: Troubleshooting
Steam or air is leaking Gasket deterioration or Replace with a new gasket between the body and damage separator body The nut on the clamp is not Tighten the nut to the proper fully tightened torque 172-65387MA-08 (SF1 Separator Filter) 1 Oct 2021... -
Page 15: Tlv Express Limited Warranty
Subject to the limitations set forth below, TLV CO., LTD., a Japanese corporation (“TLV”), warrants that products which are sold by it, TLV International Inc. (“TII”) or one of its group companies excluding TLV Corporation (a corporation of the United States of America), (hereinafter the “Products”) are designed and manufactured by TLV, conform... - Page 16 WARRANTY NOT NEGATED HEREBY, AND ANY IMPLIED WARRANTY NOT NEGATED HEREBY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, DO NOT COVER, AND NEITHER TLV, TII NOR ITS TLV GROUP COMPANIES WILL IN ANY EVENT BE LIABLE FOR, INCIDENTAL OR...
-
Page 17: Service
Service For Service or Technical Assistance: Contact your TLV representative or your regional TLV office. In Europe: Tel: [49]-(0)7263-9150-0 Daimler-Benz-Straße 16-18, 74915 Waibstadt, Germany Fax: [49]-(0)7263-9150-50 Tel: [44]-(0)1242-227223 Units 7 & 8, Furlong Business Park, Bishops Cleeve, Gloucestershire GL52 8TW, U.K.
Need help?
Do you have a question about the SF1 and is the answer not in the manual?
Questions and answers