Table of Contents
Advertisement
FURTHER INFORMATION
Troubleshooting
The camcorder is a microcomputer-controlled
device. External noise and interference (from
a TV, a radio, etc.) might prevent it from
functioning properly.
The following phenomena are not
malfunctions.
•
The camcorder heats up when it is used
for a long time.
•
The battery heats up during charging.
•
When playing back a video file, the
image stops momentarily or the sound is
interrupted at junctions between scenes.
Trouble
No power is supplied.
No display appears.
The displayed amount
of remaining battery
power differs from the
actual operating time.
The power does not
turn on, or the battery
operation time is
extremely short even
after the battery is fully
charged.
The power/charge
lamp on the camcorder
does not light during
charging.
•
•
•
L
•
Connect the AC adapter securely.
•
Detach the battery pack once again and reattach it firmly.
•
Replace the dead battery with a fully charged one.
•
If the camcorder is not operated for 5 minutes while the
power is on, it turns itself off automatically to conserve
power. To turn the camcorder on again when using the
battery pack, close the LCD monitor and open it again.
When using the AC adapter, perform any operation such
as zooming.
•
Adjust the brightness of the LCD monitor.
•
Fully charge the battery, and then run it down. If the
problem persists, the battery is worn out and needs to be
replaced. Please purchase a new one.
•
Make sure to use the camcorder under appropriate
operating temperatures.
•
The battery is worn out and needs to be replaced. Please
purchase a new one.
•
Charging may stop in places subject to extremely high/low
temperatures to protect the battery. It is recommended to
charge it in places with a temperature of 10°C to 35°C.
•
When the battery is already fully charged, the lamp does
not light. Check the remaining battery power.
To solve the problem, first follow the
instructions below.
If the problem is not solved, reset the
camcorder. (Z below)
If the problem persists, please consult your
nearest JVC dealer.
To reset the camcorder
1) Close the LCD monitor to turn off the
camcorder and remove the power
supply (battery pack or AC adapter)
from the camcorder, then reattach it.
2) Select [FACTORY PRESET] from the
MENU. (Z pg. 64)
Action
Z
17
17
–
–
63
17
72
–
–
19
Advertisement
Table of Contents
