Wen 20691 Instruction Manual page 16

USING THE TRACK LOCK
The track lock (Fig. 7 - 1) is an added measure to prevent
the track saw from separating from the track.
1. Push the track lock to the right to disengage, then set the
track saw onto the track.
2. Once the saw is sitting properly on the track, push the
track lock to the left to engage. This hooks a small plate on
the base of the saw under the lip of the track, preventing the
saw from separating from the track.
USING THE FINE-ADJUSTMENT KNOBS
There are two fine-adjustment knobs on the base of the saw
to help eliminate play between the track guide rail and the
track slot on the base of the saw.
1. Loosen the fine-adjustment cam knobs (Fig. 7 - 2) by
turning them counter-clockwise until they stop.
2. Set the track saw on the track, ensuring that the track rail
enters the slot in the saw base (Fig. 7 - 3).
3. Turn the fine-adjustment cam knobs clockwise until the
play has been taken out of the track saw's movement in
the track. Avoid overtightening so that the saw has smooth
movement.
4. Move the saw forward along the track, ensuring its movement is smooth. Repeat step 3 if adjustments are needed.
DANGER! Never try to use a blade larger than the stated capacity of the saw. Install the suitable blade for your
cutting operation. See page 2 for specifications and saw blade safety.
DANGER! Always wear gloves while handling blades to prevent cuts and injuries.
CHANGING THE SAW BLADE
1. Make sure the saw is OFF and the battery is removed. Turn the mode selector switch to the blade changing setting
(p. 14, Fig. 2).
2. Press and hold the plunge lock button (Fig. 8 - 1) and plunge the saw downwards until the arbor screw is visible
in the blade guard window. Release the plunge lock button; the saw should now be locked in place and unable to be
plunged or raised.
3. Press and hold the spindle lock (Fig. 8 - 2), then use the included hex wrench to loosen the arbor screw. Turn the
arbor screw counter-clockwise to loosen.
4. Remove the screw and outer flange. Slide blade off the arbor and downwards until it is clear of the blade guard.
5. Install the new blade on the arbor. Ensure that the blade rotation direction is correct. The blade spins counter-
clockwise, so orient the saw blade so that at the bottom of the blade, the teeth are pointing toward the front of the
saw (pointing counter-clockwise) (Fig. 9). Install the outer flange and arbor screw. Press and hold the spindle lock
button, then use the hex wrench to tighten the arbor screw.
6. Press and hold the plunge lock button to release the saw, then raise it.
16
ASSEMBLY & ADJUSTMENTS
3 2 1
1
Fig. 7
2
Fig. 8
2
Fig. 9