Wen 20691 Instruction Manual page 15

C. SCRIBE CUTS
1. Turn the mode selector switch (Fig. 2 - 1) to the scribe
cut function.
2. Press the plunge lock button (Fig. 4 - 1) and plunge the
saw downwards. It will stop at a 2.5mm (0.1 in) depth of
cut (with track).
NOTE: An initial scribe cut (before additional cuts) helps
prevent friction on the blade, particularly when deep plunge
cuts are required. It is also helpful for initial cuts on ve-
neered or melamine laminates.
ADJUSTING THE BEVEL ANGLE
The saw can be beveled between -1º - 47º.
1. Make sure that the saw is OFF and the battery is removed.
Loosen both bevel lock knobs (Fig. 5 - 1). Bevel the saw
so that the indication arrow (Fig. 5 - 2) is pointing to the
desired angle on the bevel scale (Fig. 5 - 3).
2. Tighten both bevel lock knobs to lock the bevel angle into
place.
3. Make a test cut in a piece of scrap material. Measure the
angle of the cut to confirm that the bevel angle is properly
set. If necessary, re-adjust the bevel angle before cutting
the actual workpiece.
NOTE: The bevel indication arrow should be properly ad-
justed at the factory. If you find that it is inaccurate, adjust
it using the steps below.
1. Make a test cut. Measure the bevel angle.
2. Loosen the screw (Fig. 5 - 4) on the bevel indication arrow. Adjust the arrow so that it points to the angle of the
cut. Tighten the screw.
-1º BEVEL CUTTING
Your saw is capable of making -1º beveled cuts.
1. Loosen both bevel lock knobs (Fig. 5 - 1).
2. Press the levers (Fig. 6 - 1) on the base of the saw towards the blade housing as shown in Fig. 6.
3. Set the bevel angle to -1º and retighten the bevel lock knobs.
ASSEMBLY & ADJUSTMENTS
1
3
1
4
2
1
Fig. 4
Fig. 5
Fig. 6
1
15