Table of Contents
Advertisement
Note
• If you choose PEAP or EAP-TTLS, you do not need to do this.
•
11.
11. Set up Weak encryption restriction.
Select Restrict.
12.
12. Set up Weak certificate restriction.
Select Restrict.
13.
13. Select Enable/disable IEEE802.1X/EAP to enable IEEE802.1X/EAP
Select OK and save the settings to enable IEEE802.1X/EAP.
Note
•
• You can enable or disable IEEE802.1X/EAP on the operation panel.
Note that the advanced IEEE802.1X/EAP settings are not available on the operation panel.
14. Connect to IEEE802.1X/EAP switch (Authenticator) or IEEE802.1X/EAP access point.
14.
When IEEE802.1X/EAP is enabled, it is possible to search for SSIDs of IEEE802.1X/EAP access
points in Manual setup on the operation panel.
Select the SSID of the IEEE802.1X/EAP access point to connect.
If You Cannot Connect
If you are unable to connect to the IEEE802.1X/EAP switch (Authenticator) or access point, please redo
the settings from step 3 above.
Important
•
• Wireless Direct is disabled when you connect to an IEEE802.1X/EAP access point. When using
the Remote UI, enable Wireless Direct from the operation panel settings and connect again using
Wireless Direct.
Note
• Select Settings on HOME screen and select LAN settings > Wi-Fi > Advanced > IEEE802.1X/EAP
•
settings > Latest authentication result to help troubleshoot.
1. Check that the wireless router is turned on is displayed when the switch/access point may not be
1.
turned on.
2. If the error cannot be identified, such as multiple problems occurring, An unexpected error has
2.
occurred. is displayed.
3.
3. If a connection processing problem or encryption-authentication mismatch is detected, Failed to
connect to the wireless router <Refer to manual> is displayed.
45
Advertisement
Table of Contents
