Maintenance; Protecting The Environment - DeWalt DCK665P3T Original Instructions Manual

2. Twist the chip deflector (Fig. K2,
bag to separate.
3. Gently shake or tap the dust bag to empty.
4. Reattach the dust bag back onto the AirLock connection.
You may notice that all the dust will not come free from the
bag. This will not affect planing performance but will reduce
the planer's dust collection efficiency. To restore your planer's
dust collection efficiency, depress the spring inside the dust bag
when you are emptying it and tap it on the side of a dustbin.
nOTE: A D WALT AirLock Adapter (DWV9000) can be
e
purchased separately to connect a shop vacuum or D
dust extractor to your planer.

CAUTION: Never operate these tools unless the dust
collector is in place. Planing dust exhaust may create a
breathing hazard.

MAINTENANCE

Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Chip Ejection Port Cleaning Instructions (Fig. A)
If the unit is clogged with dust or chips, use a non-metallic stick
to push the obstruction out of the chip ejection port
stick your finger into the port.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
31 ) away from the dust
WALT
e
11 . Never
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
English
WALT recommended
e
13