Table of Contents
Advertisement
Setup
Setup
OSD Settings
Language
Transparency
Information OSD
Power save settings
Energy Mode
Power Save
Quick Start
Auto Power Down
Auto Input Change
None
First
Custom
HDMI Settings
CEC
EDID
Video Range
HPD Delay
Select the language used in the OSD.
Set the transparency level of the OSD menu between 30%, 50%, 70% and Off.
The higher the percentage, the more transparent the OSD menu is.
Displays or hides the Information OSD.
Information OSD contains the messages that are displayed on the screen when the input is
switched or when the state of the input signal changes.
Enables or disables the monitor entering power saving mode.
Select a mode between Home, Retail, and Office.
For more information, see "Energy Mode"
Sets the time until the monitor enters the Power Save mode. When the set time has elapsed
after the input signal has been lost, the Power Save function is activated.
When [On] is selected, the monitor will quickly return to the [On] state when a signal is
detected. Enabling this option increases standby power consumption.
When turned [On], the monitor turns off automatically after 4 hours without any operation.
This function automatically selects the input terminal with an input signal.
When enabled, this option can detect and change inputs when a signal is applied or lost.
Press the INFO button of the remote control to display the selected input terminal on the
Information OSD.
The monitor does not search for video signal on the other input connections.
The monitor does not search for a video signal on the other input connections while the current
input has a video signal.
If the current input connection does not have video signal present, the monitor will search for
video signal on the other video input connections. If a video signal is found, the monitor will
switch from the current input to the input with the active video source automatically.
The input terminals included in the search performed by the monitor can be selected.
This function makes it possible to control a device supporting HDMI CEC connected to the
HDMI terminal.
When set to On, HDMI CEC is enabled.
Sets the HDMI mode.
Mode 0E: Max resolution is 1920 x 1080 (60 Hz).
Mode 1E: Max resolution is 3840 x 2160 (30 Hz).
Mode 2E: Max resolution is 3840 x 2160 (60 Hz), HDCP 2.2, or HDR.
Adjust the gradation range to be shown according to the video signal to improve the whiteout
and blackout of the image.
This function makes it possible to control the time until the video from the HDMI terminal is
displayed.
When set to Off, the time until the video is output can be reduced but the video may not be
output depending on the device. In such a case, set [HPD Delay] to On.
page
34.
English - 73
Advertisement
Table of Contents
