Montarbo W22A Instruction Manual page 12

W22A
bi-amped, active loudspeaker system
Important !
Power supply connection:
• Make sure that the mains voltage corresponds to
the voltage indicated on the rear panel, under the mains
socket.
Wiring of the power cable for the
PowerCon connector (supplied with the unit):
®
Strip the cable for 20 mm of length and strip each wire for
8 mm of length. We suggest to use a power cable with
1,5 ÷ 2 mm 2 section wires (the insert terminals can however
support a cable with wires up to a section of 4 mm
Insert the power cable into the bushing and into the chuck
(white chuck for a cable diameter of 5 ÷ 11 mm; black chuck
for a cable diameter of 9.50 ÷ 15 mm).
Fit a ferrule at the end of each wire and connect wires on
the insert.
The wire ends can be clamped in or soldered to the
terminal. Always paying attention to the symbols shown
on the connector:
L (Live - corresponding to the brown wire),
N (Neutral - corresponding to the light blue wire) and
(Ground - corresponding to the yellow and green wire).
After connecting the wires to the insert, lead the cable
through the housing and screw down the bushing.
• Use only the factory supplied mains cable or, if a different
plug style is needed, a suitable cable with a ground
connection and marked with the safety approvals valid in
the country of use.
20 mm
8 mm
/12AWG).
2
WIRES
FERRULES FOR
STRANDS
WIRES
INSERT
HOUSING
CABLE
CABLE
CHUCK
INSIDE VIEW
L
®
POWER CON
ENGLISH
BUSHING
N
SETSCREWS
CONNECTOR
12