RIOTEC RIOSCAN iLS6303AS Quick Manual

RIOSCAN Laser Barcode Scanner
Quick Guide
M o d e l n o . :
i L S 6 3 0 3 A S
Introduction
Designed primarily for smartphone, the iLS6303AS is a 1D
barcode scanner that allows you to scan various barcoded
items and send data to smartphone.
Its in-built 1D Laser Engine allows you to reliably read 1D
barcodes on various shapes and is a great space-saver for
busy or limited workspaces.
It supports not only iOS devices through Bluetooth
communication, but also Android OTG devices through USB
cable
Delivery content
Bluetooth Barcode scanner x 1
*
Charging cradle x 1
*
* PCB material board+3 screws x 1
Holder for smartphone x 1
*
USB cable x 1
*
Quick instructions x 1
*
Limited Warranty
Riotec provides a one year limited warranty.
This warranty does not cover any product which has been subject
to improper use, neglect or unauthorized repair or installation.
This warranty does not cover consumable parts. (Cables &
batteries are consumables.)
Safety instructions
* The product is equipped with a Class 1 laser.
* Never look into the laser beam and never point it at people or
animals. Laser radiation can seriously damage your eyes.
Do not point the laser beam at mirrors or other reflective surfaces.
*
The uncontrolled, reflected beam may strike people or animals.
Don't put scanner in places excessively high temperatures, such as
*
expose under direct sunlight.
Don't use scanner in extremely humid area or drastic temperature
*
change
* The rechargeable battery is permanently built into the product and
cannot be replaced.
* Never damage the rechargeable battery. Damaging the casing of
the rechargeable battery might cause an explosion or a fire!
1
Charging:
Please switch on and charge scanner for 3~4 hours before first use
1.
as shown on Fig.
2. When user charge smartphone & scanner, please use smartphone
original USB power adapter
3. The cradle functions as a charger for the scanner. Even if the
scanner's battery is full, the cradle will continue to supply power to
the scanner. We suggest removing the scanner from the cradle
when fully charged.
When you charge scanner & smartphone, please enter Wired OTG
4.
mode & switch to "C- Charging mode"
.