RIOTEC RIOSCAN iLS6302JS Quick Manual

RIOSCAN 2D barcode scanner
Quick Guide
M o d e l n o . :
i L S 6 3 0 2 J S
i L S 6 3 0 2 K S
i L S 6 3 0 2 L S
i L S 6 3 0 2 N S

Introduction

Designed primarily for smartphone, the scanner is a 2D
barcode scanner that allows you to scan various barcoded
items and send data to smartphone.
Its in-built ZEBRA engine allows you to reliably read 2D
barcodes on various shapes and is a great space-saver for
busy or limited workspaces.
It supports not only iOS devices through Bluetooth
communication, but also Android OTG devices through USB
cable

Delivery content

Bluetooth Barcode scanner x 1
*
Charging cradle x 1
*
Holder for smartphone x 1
*
USB cable x 1
*
Quick Guide instructions x 1
*

Limited Warranty

Riotec provides a one year limited warranty.
This warranty does not cover any product which has been subject
to improper use, neglect or unauthorized repair or installation.
This warranty does not cover consumable parts. (Cables &
batteries are consumables.)

Safety instructions

Never look into the laser beam and never point it at people
*
or animals. Laser radiation can seriously damage your
eyes.(for iLS6302KS)
Do not point the laser beam at mirrors or other reflective
*
surfaces. The uncontrolled, reflected beam may strike
people or animals. (for iLS6302KS)
Don't put scanner in places excessively high temperatures,
*
such as expose under direct sunlight.
Don't use scanner in extremely humid area or drastic
*
temperature change
The rechargeable battery is permanently built into the
*
product and cannot be replaced.
Never damage the rechargeable battery. Damaging the
*
casing of the rechargeable battery might cause an
explosion or a fire!
1

Charging:

1. Switch on and charge the scanner for 3~4 hours before first
usage as shown on Fig.2. Please shift the switch of the scanner
to C mode (Charging mode) to charge.
2. The On and Off switch is located at the bottom of the handle.
You may use a fine and thin stick, then carefully press into it until
you hear a low clicking sound.
3. When you want to charge the smartphone & scanner, please use
smartphone original USB power adapter.
4. The cradle functions as a charger for the scanner. Even if the
scanner's battery is full, the cradle will continue to supply power
to the scanner. We suggest removing the scanner from the cradle
when fully charged.
5. When you charge the scanner with the smartphone, please enter
Wired OTG mode & switch to "C- Charging mode".