Timer Play; About Balanced Jacks - Marantz SA-11S1 User Manual

OPERATION

TIMER PLAY

This unit can perform timer play by cooperating with your audio
timer.
Connect this unit's power cord to the audio timer's power socket
and the timer's power cord to power outlet.
* For connection to audio timer and it's operation, please refer
to the instruction manual of your audio timer.
Setting method of Timer Play
q Press POWER switch to turn ON the power.
w Insert the disc to be played.
* In timer play mode, tracks are played normally.
e Set the audio timer.
Audio Timer

ABOUT BALANCED JACKS

q The balanced output connector uses a XLR connector.
w The XLR connector for professional use is internally wired
in either of the following two systems.
1. USA system (Pin w = COLD, Pin e = HOT)
COLD
w q
e
HOT
2. European system (Pin w = HOT, Pin e = COLD)
w q
HOT
e
COLD
e The SA-11S1 uses the 1. USA system.
When a preamp or main amplifier adopting the European
system is connected using a cable with XLR balanced
connectors, the reproduced signal may be inverted of
phase.
In this case, correct the wiring of the one of the XLR
connectors on the extremities of the cable to the USA
system by exchanging the connections of pins w and e.
This will make it possible to play the signal with the correct
phase.
GND
GND
21