Table of Contents
Advertisement
Using the trimmer base with the
offset base plate and grip
The offset base plate can also be used with a trimmer
base and a grip attachment (optional accessory) for
more stability.
1.
Loosen the screws on the offset base plate, then
remove the offset base plate from the offset base.
Fig.62
► 1. Offset base plate 2. Trimmer base plate
2.
Attach the offset base plate to the trimmer base by
tightening the screws.
3.
Attach the grip attachment and the bar type grip to
the offset base plate by tightening the screws.
1
2
Fig.63
► 1. Bar type grip 2. Grip attachment
1
2
The knob type grip removed from the plunge base can be
installed on the offset base instead of the bar type grip.
1
2
Fig.64
► 1. Screw 2. Knob type grip
Using the tool with the plunge base
Always hold the grips firmly with both hands during opera-
tion. Operate the tool in the same way as the trimmer base.
Using the straight guide
Optional accessory
1.
Install the straight guide to the guide holder by tight-
ening the wing nut. Insert the guide holder into the holes
in the plunge base, and then tighten the wing bolts.
Fig.65
► 1. Wing bolt 2. Guide holder 3. Wing nut 4. Straight guide
2.
Loosen the wing nut on the straight guide and adjust
the distance between the trimmer bit and the straight
guide. At the desired distance, tighten the wing nut.
Fig.66
► 1. Wing nut
20 ENGLISH
1
2
3
4
1
Advertisement
Table of Contents
