Makita RT001GZ18 Instruction Manual page 13

To remove the base, follow the installation procedure
in reverse.
NOTE: You can also mount the belt to the pulley with-
out removing the base plate as shown in the figure.
Fig.25
► 1. Pulley 2. Belt
Installing or removing the plunge
base
Optional accessory
1. Open the lock lever of the plunge base, then insert
the tool into the plunge base all the way aligning the
groove on the tool with the protrusion on the plunge
base.
2.
Close the lock lever.
Fig.26
► 1. Lock lever
To remove the base, follow the installation procedure
in reverse.
Installing or removing the parallel
ruler on the plunge base
Optional accessory
Insert the guide bars into the holes in the plunge base,
and then tighten the wing bolts. To remove the ruler,
1
follow the installation procedure in reverse.
2
2
Fig.27
► 1. Wing bolt 2. Guide bar
Installing or removing the dust
nozzle on the plunge base
Insert the dust nozzle into the plunge base so that the
protrusion on the dust nozzle fits in the notch in the
plunge base, and then tighten the thumb screw on the
dust nozzle. To remove the nozzle, follow the installa-
tion procedure in reverse.
1
1
2
Fig.28
► 1. Protrusion 2. Dust nozzle 3. Thumb screw
Fig.29
13 ENGLISH
1
3