Table of Contents
Advertisement
Installing or removing the trimmer
base
1.
Open the lock lever of the trimmer base, then
insert the tool into the trimmer base aligning the groove
on the tool with the protrusion on the trimmer base.
2.
Close the lock lever.
Fig.10
► 1. Lock lever
NOTE: You can use the trimmer base (resin) as an
optional accessory as shown in the figure. When
using the trimmer base (resin), loosen or tighten the
thumb nut instead of opening or closing the lock lever.
Align the rack on the tool with the spur gear on the
trimmer base.
Fig.11
► 1. Thumb nut 2. Rack 3. Spur gear
1
2
1
3
10 ENGLISH
3.
Attach the dust nozzle to the trimmer base, and
then tighten the thumb screw.
Fig.12
► 1. Dust nozzle 2. Thumb screw
Fig.13
To remove the base, follow the installation procedure
in reverse.
CAUTION:
When using the tool with the trim-
mer base, be sure to install the dust nozzle on the
trimmer base.
1
2
Advertisement
Table of Contents
