JRC JHS-182 Instruction Manual page 65

[Explanation of the setting menus]
1. CH A
2. CH B
1. 2. are a menu for setting channel number and bandwidth.
By rotating Jog Dial, input the channel number and confirm it by pressing the Dial.
No. : Set up to the channels which are used.
BANDWIDTH : Select the bandwidth from WIDE/NARROW
3. TX/RX MODE :
This menu is used for setting the transmission/receive (TX/RX) mode of CH A and CH B.
With Jog-Dial, select a combination of communication method.
Turn the Jog Dial left then the number changes 1→2→3 from 3 patterns below:
1.TX/RX,TX/RX (CH A → TX/RX、CH B → TX/RX)
2.TX/RX, RX (CH A → TX/RX、CH B → RX)
3.RX, TX/RX (CH A → RX、CH B → TX/RX)
Press the Jog Dial for confirming the selection.
Setting as (RX, RX) cannot be selectable.
4.TX POWER: Select the TX Output Power(HIGH/LOW).
This menu is for setting the transmission power.
The power of each setting is:
High......12.5W
Low.........2W
Rotate Jog Dial and select from High or Low.
Press the Jog Dial for confirming the selection.
5.ZONE SIZE : Set up the width of the channel change zone.
Set the range with Jog Dial.
The range can be input between 1 and 8NM.
Press the Jog Dial for confirming the entry.
6,7. Coordinates in area : Set up the coordinates of area.
By setting NE at 6, SW at 7, define the area.
When cursor is on 6, press the Jog Dial.
The cursor moves to the right of ":", turn the Jog Dial and select "N".
Press the Jog Dial for confirming "N".
Enter numeric value for "xxx゜xx.xx'" and press for confirmation.
Follow the procedure above, enter value for E (East), S(South) and W(West).
8. Change direction of the Regional Channel：
When 8. is selected, the information about a setting direction is provided.
Here only displaying the information, no selections/changes are made.
SOURCE...The contents of directions received
MMSI...MMSI of the origin of the setting direction
UTC...The UTC time when the direction was accepted
5-44