Table of Contents
Advertisement
• When shooting fast-moving subjects or
performing panning/tilting operations,
objects crossing the shooting area may
look to be bending askew.
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury.
Do not use benzine, thinner, alcohol, or any
other types of solvents or detergents.
Otherwise, it may cause discoloration. When
using a chemical cloth for cleaning, read the
caution provided with the chemical cloth
product.
• Do not loozen or remove screws unless
instructed to do so in the product docu-
mentation.
• The camera position may be moved inad-
vertently while cleaning the camera body.
Restart the product or refresh the camera
position (position refresh) to correct the
camera position. Refer to the Operating
Instructions for further information.
Cleaning of the dome cover
Use lens cleaning paper (used to clean camera
or spectacles lenses) to remove any dirt on the
dome cover.
About the stabilizer function
Depending on the conditions in the installation
area, effects of the stabilizer function may not
be fully achieved.
Consumable parts
The following are consumables: Replace them
in accordance with their operating lifetimes.
Their operating lifetimes vary depending on the
usage environment and conditions. The oper-
ating lifetimes below are just guides for when
using the camera at +35 °C {95 °F}.
• Lens unit, panning motor, tilting motor, thin
wire coaxial cable, flat cable for tilting:
Approx. 3.7 million operations (Approx.
20000 hours)
Do not hold the dome section.
The dome section of this unit rotates. When
removing this unit from a ceiling or wall, turn
the unit while holding the fixed section.
Motor operating sound
The operating sound may be louder depending
on the speed of panning/tilting operations.
When you feel uneasy, the operating sound
can be diminished by reducing the setting
value of auto panning speed.
AVC Patent Portfolio License
THIS PRODUCT IS LICENSED UNDER THE
AVC PATENT PORTFOLIO LICENSE FOR THE
PERSONAL USE OF A CONSUMER OR
OTHER USES IN WHICH IT DOES NOT
RECEIVE REMUNERATION TO (i) ENCODE
VIDEO IN COMPLIANCE WITH THE AVC
STANDARD ("AVC VIDEO") AND/OR (ii)
DECODE AVC VIDEO THAT WAS ENCODED
BY A CONSUMER ENGAGED IN A
PERSONAL ACTIVITY AND/OR WAS
OBTAINED FROM A VIDEO PROVIDER
LICENSED TO PROVIDE AVC VIDEO. NO
LICENSE IS GRANTED OR SHALL BE
IMPLIED FOR ANY OTHER USE. ADDITIONAL
INFORMATION MAY BE OBTAINED FROM
MPEG LA, L.L.C.
SEE HTTP://WWW.MPEGLA.COM
Lens and pan/tilt head
If a lens and pan/tilt head are not performed for
a long period of time, the grease coating inside
these parts may become sticky. That may
obstruct the parts from moving. To prevent
this, move the lens or pan/tilt head periodically.
Or perform position refresh periodically in the
manner described in "Position refresh".
Position refresh
During the use for a long period of time, the
preset positions may become inaccurate.
When "Position refresh" is set for the created
schedule, the camera position will be corrected
periodically.
Refer to the Operating Instructions for how to
perform the settings.
7
Advertisement
Table of Contents
