i-PRO WV-S61501-Z1 Basic Information page 13

INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
A
Follow the steps below to initialize the network camera.
(1) Turn off the power of the camera.
When using a PoE hub, disconnect the Ethernet cable from the camera. When using an
external power supply, disconnect the power cord plug (accessory) from the power supply
terminal (12V DC).
(2) Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera
will start up and the settings including the network settings will be initialized. Retry if the
camera does not start up normally.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
B LINK indicator
• When the camera is able to communicate with
the connected device
C ACT indicator
• When data is being sent via the network camera
D SD MOUNT indicator
• When a microSD memory card is inserted and could
be recognized
• When data can be saved after the microSD memory
card is inserted and the SD ON/OFF button is pressed
(less than 1 second)
• When data can be saved to the microSD memory card
• When the microSD memory card is removed after
holding down the SD ON/OFF button
(about 2 seconds)
• When data cannot be saved to the microSD memory
card because an abnormality was detected or the
microSD memory card is configured not to be used
Note:
• Lighting/blinking LED can be turned off with the software settings at any time. (The initial state
is lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation
conditions. (☞ Operating instructions on our product information website)
Lights orange
Blinks green (accessing)
Lights off → Blinks green → Lights off
Lights off → Lights green
Lights green
Lights green → Blinks green →
Lights off (recording)
Lights green → Lights off
(waiting for recording)
Lights off
13