i-PRO WV-S61501-Z1 Basic Information page 18

Symptom
The LINK indicator
does not light in
orange even when the
Ethernet cable is con-
nected to the camera.
The SD MOUNT
indicator does not
light even when a
microSD memory card
is installed.
Audio input contains
noise.
The focus can not be
automatically
adjusted.
Cause/solution
• Is the Ethernet cable connected appropriately?
Connect the Ethernet cable appropriately.
• Is the hub or router connected to the camera operating
appropriately?
Check if the hub or router in use is operating appropriately.
• Is the Ethernet cable connected to the camera broken?
Replace the cable with another one.
This indicator lights up green when the microSD
memory card is recognized correctly and ready for
use.
• Has the inserted microSD memory card been formatted
on a PC?
Use a microSD memory card formatted on the camera.
Or install the software to format the microSD memory
card on the PC.
Refer to our technical information website <Control No.:
C0105> for further information about the supported
software.
• Is the inserted microSD memory card faulty?
Replace the card with a normal one.
• Check the following.
• Grounding of the camera, a switching hub or
peripheral devices are not done.
• The camera is used near an electrical power line.
• The camera is used near a device which produces
strong magnetic field or radio waves (such as near
a TV/radio antenna, a motor of an air conditioning
system, a transformer, etc.)
When audio input still contains noise even after check-
ing the above possibilities, use a powered microphone
or connect audio output with low output impedance.
• In the following locations or with the following subjects,
the focus may not be able to be automatically adjusted.
In this case, manually adjust the focus from the setup
menu.
• When the subject moves a lot
• When there are large changes to the lighting intensity
• When the light level is low
• When the subject or location is extremely bright or
reflective
• When viewing through windows
• When the dome cover is in a locations where it can
easily become dirty
• Locations where there is not much contrast such
as a white wall
• When there is harsh flickering
18
Reference
pages
9
13
Installation
Guide
Operating
Instructions