Specac ATMOS A2.5 Quick Start Manual

Heating jacket gas cells

ATMOS™ HEATING JACKET

Quick Start Guide

For use with the Atmos A2.5, A5, A10 & A20 Gas Cells

More detailed information can be found in the Instruction Manual on the USB stick.

Step 1 – Install the heating jacket

The metal portion of the Atmos heating jacket opens

to fit around the gas cell and is secured with a latch

at the front. The latch should be at the front with the

cable exiting the back of the gas cell. Velcro is then

used to secure the insulation around the gas cell.

Ensure the gas cell is secured to the spectrometer

using the lever-lock baseplate.

Step 2 – Connect Controller

Connect the heating jacket to the 4000-series

controller. The connector is secured by rotating the

outer portion of the connector clockwise. Connect the

controller to a mains outlet using the cable provided.

QS-24650-1

Insulation

Velcro

Latch

Fig 1. Atmos Heating Jacket

Heated Jacket

Connection

Mains lead

connection

Fig 2. Controller Connection

Table of Contents

Need help?

Do you have a question about the ATMOS A2.5 and is the answer not in the manual?

Page 1 ATMOS™ HEATING JACKET Quick Start Guide For use with the Atmos A2.5, A5, A10 & A20 Gas Cells More detailed information can be found in the Instruction Manual on the USB stick. Step 1 – Install the heating jacket Insulation...
Page 2 ATMOS™ HEATING JACKET Step 3 – Set Temperature Actual Temperature Power on the controller using the switch on the front. Target Temperature This displays two temperatures: current temperature (top) in and target temperature (bottom) in green. Use the up and down buttons to adjust the target temperature.

Atmos a5Atmos a10Atmos a20