Smeg Dolce Stil Novo PM6954R Manual page 22

Connection to LPG
Use a pressure regulator and make the
connection on the gas cylinder following the
guidelines set out in the standards in force.
The supply pressure must comply with the values
indicated in the "Burner and nozzle
characteristics table".
Room ventilation
The appliance should be installed in rooms that
have a permanent air supply in accordance
with the standards in force. The room where the
appliance is installed must have enough air flow
for the regular combustion of gas and the
necessary air change in the room itself. The air
vents, protected by grilles, must be the right size
to comply with current regulations and
positioned so that no part of them is obstructed,
not even partially.
The room must be kept adequately ventilated in
order to eliminate the heat and humidity
produced by cooking: In particular, after
prolonged use, you are recommended to open
a window or to increase the speed of any fans.
Extraction of the combustion products
The combustion products may be extracted by
means of hoods connected to a natural draught
chimney whose efficiency is certain or via forced
extraction. An efficient extraction system requires
precision planning by a specialist qualified in
this area and must comply with the positions and
clearances indicated by the applicable
standards.
When the job is complete, the installer must
54 - INSTALLATION
issue a certificate of conformity.
1A 1A
2C 2C
1 Extraction using a hood
2 Extraction without a hood
A Extraction with a single natural draught
chimney
B Extraction with a single chimney with
extractor fan
C Extraction directly outdoors with wall- or
window-mounted extractor fan
D Extraction directly outdoors through wall
Air
Combustion products
Extractor fan
Adaptation to different types of gas
If other types of gas are to be used, the nozzles
must be replaced and the primary air must be
adjusted. The top of the hob has to be removed
in order to replace the nozzles and adjust the
burners.
In order to be able to replace the
nozzles, the appliance must be
removed from the built-in unit.
Removing the hob top
1. Pull the knobs and the knob bezels (where
present) upwards to remove them. Pay
attention to the spring between the knob
and the bezel.
2. Remove the pan support grids from the hob.
1B 1B
2D 2D
91477A185/C