Toyota 2H Repair Manual page 246

L U B R ICATIO N S Y S T E M
( b ) Insert the
block
sealer a n d remove the o i l pan.
SST
090 3 2 - 00 1 00
C A U T I O N :
•
Do not use SST for the t i m i n g gear case side and
rear o i l seal retainer side. (2H)
•
Be careful not to damage the o i l
9 . REMOVE O I L STRAI N E R AND OIL PIPE
(a) Remove the two bolts, two n u t s . o i l strainer and
gasket.
(b) Remove t h e u n i o n b o l l . two n u ts, o i l p i pe a n d
g a s k e t s .
[ 1 2 H - Tl
1 0 .
R E M O V E S T I F F E N I N G PLATE
Insert the SST blade between t h e stiffening plate and
cylinder block,
s t i f fe n i n g plale.
SST 0 9 0 3 2 - 00 1 00
C A U T I O N :
•
D o n o t u s e S S T for t h e t i m i n g gear case s i d e a n d
rear o i l s e a l retainer side.
•
Be careful not to damage the s t i f f e n i n g plate.
1 1 . R E M O V E O I L PUMP
Remove t h e e i g h t bolts. o i l pump, gasket and O-ring.
-
O i l Pump
S S T
blade between t h e o i l pan a n d cylinder
( 2 H ) or s t i f fe n i ng plate ( 1
c u t
off a p plied sealer and remove the
L U - 7
2H- T),
c u t
o f f applied
pan
flange.