Peavey AQ 12 Operating Manual page 17

Mounting provisions:
Four rubber feet provide vibration free floor or stage use, and a molded-in stand mounting cup with industry
standard 1 3/8" inside diameter for use with subwoofer poles and speaker stands is on the bottom. Unit is not
designed to be flown overhead.
Overall Dimensions ( H x W x D )
25.3"H x 14.38"W x 14.00"D
643 mm x 366 mm x 356 mm
Weight: 34 lbs. (15.4 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Internal power amplifiers (@120 VAC line):
Total of 1000 watts peak dynamic power
Woofer - 670 watts peak dynamic power
Sine Wave Power: 240 watts @ less than 1% distortion*
Tweeter - 330 watts peak dynamic power
Sine Wave Power: 120 watts @ less than 1% distortion
* Before DSP compression and limiting engages
Electronic Input Impedance (Nominal):
Line: 4.5 k ohms balanced (XLR or 1/4")
Mic: 4.5 k ohms balanced (XLR) No phantom power available.
Input Sensitivity for Full Output (LEVEL full CW): 0.50 V RMS
(Switch in LINE position)
Input Overload Point (Switch in LINE position): +18 dBV
Infrasonic filter protection: 36 dB/octave roll-off
Nominal Amplifier Frequency Response: +1, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
THD and IM: Typically less than 0.7 %
Power requirements of Peavey AQ™12 System:
Nominal 200 Watts, 120 VAC 60 Hz