Table of Contents
Advertisement
control on the AQ™12) needs to be reduced.
When first turning on the sound system, switch on all upstream electronics first, then the AQ™12 with its level
control fully counterclockwise (all the way down). Begin checking levels with the mixer output Gain controls all
the way down, and bring them up slowly with the AQ™12 level control set to the
desired setting (one-third way up recommended to start).
It is not good practice to turn the level control on the AQ™12 all the way up and then try to control level only
from the mixer, this approach would tend to pick up excess noise. Best practice would be to run a "hot" signal
from the mixer down the cable to the AQ™12, and then turn the AQ™12 level control up only as much as neces-
sary to reach full desired output. With this approach, it is necessary to verify the mixer output is not clipping.
Bluetooth
Bluetooth® Pairing
Use this button (10) to link your Bluetooth® source (phone, tablet, etc...) to the speaker. See Bluetooth® Operation
below.
Bluetooth® Stereo Link
Use this button (9) to link your speaker to second AQ™12 speaker. See Bluetooth® Operation below.
Bluetooth® Operation:
Pairing: To pair your Bluetooth® source to the speaker, use the following steps:
1. Press mode button (10) on the back of the speaker to make the speaker discoverable. The pairing LED should
start blinking.
2. Go to your devices Bluetooth® screen and select the available Peavey speaker. Once paired, the pairing LED
should light continuously.
Stereo Linking: To link two compatible Peavey AQ™ series speakers, use the following steps:
1. First, use the previous steps to pair your Bluetooth® device to the first speaker.
2. Press Pairing button (10) on the second speaker to turn the Bluetooth® on.
3. Press Stereo Link button (9) on both speakers. Once the connection has been made, the Stereo Link LED 's on
both speakers should be on continuously.
4. To disconnect, press the Stereo Link button again on either speaker.
Difficulties Pairing or Linking Speakers
If you experience any difficulty in getting the Peavey speaker to pair with your Bluetooth® signal source device,
make sure that it is not still paired to a different Bluetooth® signal source device that it was paired with earlier,
one that is On, and within range of the AQ™12 speaker system. If such a condition exists, then Disconnect the
Peavey speaker from the previous Bluetooth® signal source device, and then go through the relevant steps out-
lined above.
Bluetooth® Range Information
This is a Class 2 Bluetooth® device, and as such is designed to have a typical maximum range of approximately
10m (33 feet).
However, any intervening materials, such as walls, shelves, screens, people, or most anything made of a substan-
tial amount of metal, can reduce and affect that range.
Advertisement
Table of Contents
