Jack Assignments; Main Terminal Strip Pin Assignments; Dc Terminal Strip Pin Assignments; A/C Terminal Strip Pin Assignments - Honeywell HW-TG7LAF02 Installation And Operating Manual

Jack Assignments

Connects
Jack
To
Incoming
Gray
Telco RJ-45
(J14)
jack.
Digital
Dialer
Black
input/outpu
(J13)
t of host
alarm panel.

Main Terminal Strip Pin Assignments

Terminal
Definition
Strip Pin
Supervisory Relay Trip
1 STC2 output for programmable
2 STC2 trouble conditions.
Normally Closed.
Supervisory Relay Trip
3 STC1 output for programmable
4 STC1 trouble conditions.
Normally Open.
5 GND Trip Ground
6 IN Trip Input

DC Terminal Strip Pin Assignments

Terminal
Definition
Strip Pin
1 GND DC Power
2 DC input

A/C Terminal Strip Pin Assignments

Terminal
Definition
Strip Pin
LS10265-000HW-E:C 04/27/2021
Pin Assignment
1 = Brown R1
2 = Blue
4 = Green R (Ring)
5 = Red T (Tip)
7 = Orange
8 = Gray T1
1 = Brown R1
2 = Blue
4 = Green R (Ring)
5 = Red T (Tip)
7 = Orange
8 = Gray T1
Connects To
24-hour trip
zone input on
alarm panel.
24-hour trip
zone input on
alarm panel.
External trip
relay.
External trip
relay.
Connects To Function
12VDC Power
Source (or TG- Powers up the unit
PEM)
Connects To Function
firealarmresources.com
Function
Connects Telco line to
TG-7 series.
Connects alarm panel
to TG-7 series for
transmitting alarms to
central station.
Function
Enables transmission of programmed
supervisory trouble code (see diagram
or installation section).
Enables transmission of programmed
supervisory trouble code (see diagram
or installation section).
Allows an external relay to trigger an
alarm signal.
Allows an external relay to trigger an
alarm signal.
Note
DC power up should not be paired up with
AC or battery connections.
Status LED Reference
23
Status LED
Reference
STC LED 2 will flash
3 times when Telco
voltage is lost.
If PPF is ENABLED,
STC LED 2 will flash
7 times when alarm
panel is not detected
and PPF enabled.
Status LED
Reference
STC LED 2
STC LED 2
56052901 – Rev B