Makita BTD042 Instruction Manual page 9

ON
2
3
1. Indicating lamp
2. Switch trigger
3. Battery cartridge
1
2
1. Tool housing
2. Screwdriver
OFF
1. Pulling the trigger, insert the battery cartridge. Keep on
001259
pulling the trigger after inserting the battery cartridge.
1
(The indicating lamp on the back of the tool will flash
about 10 times, then the lamp will keep lighting up lit.)
2. Hit the tool housing around the grip once with a screw-
001260
driver etc. (The indicating lamp will go out.)
3. Release the trigger. (The indicating lamp will keep light-
001261
ing up lit for 0.5 seconds, then the lamp will go out.)
4. Hit the tool housing preset number of first digit except 0.
(The indicating lamp will light up in green color. Then,
the light goes out.)
5. Pull the trigger, then release it.
6. Hit the tool housing preset number of second digit
except 0. (The indicating lamp will light up in red color.
Then, the light goes out.)
7. Pull the trigger, then release the trigger. (The indicating
lamp will light up.)
8. Remove the battery cartridge. (Presetting has finished.)
(The indicating lamp will go out.)
CAUTION:
• When you change the presetting, do the same
procedure as above 1 - 8.
Confirming the presetting
Switch off the tool and insert the battery cartridge. The indi-
cating lamp will indicate the presetting number. Green lamp
shows the first digit. Red lamp shows the second digit.
9