Removing The M.2 Ssd Module - Clevo NP70PNP Service Manual

Disassembly

Removing the M.2 SSD Module

Figure 8
M.2 SSD-1 Module
M.2 SSD-1 Removal Procedure
Removal
1. Turn off the computer, turn it over, remove the battery
2. The M.2 SSD module will be visible at point
a. Locate the M.2 SSD.
3. Remove the screw
b. Remove the screw.
c. The M.2 SSD module
4. The M.2 SSD module
will pop up.
5. Reverse the process to install a new module (do not forget to replace the thermal pad, screws and bottom cover).
a.
b.

3.M2 SSD Module
SATA/PCIE
• 1 Screw
2 - 12 Removing the M.2 SSD Module
(Figure 8b).
2
(Figure 8c) will pop-up, and you can remove it from the computer.
3
1
2
(page 2 - 5).
on the mainboard (Figure 8a).
1

Thermal Pad
Make sure to place the
thermal pad's adhesive
side down on the module's
surface as illustrated.
c.
3
3